Ford/New Holland Wiring Harness
Fits tractor(s) : $52.52 eachMore Info |
Ford/New Holland Water Pump Front Pump Only
Fits tractor(s) : $141.05 eachMore Info |
TIRE ONLY
Fits tractor(s) : 1200, 2000 SERIES, 2110, 2120, 2130, 231, 2610, 2810, 2910, 3000, 3310, 3430, 3600, 3610, 3900, 3910...$199.03 eachMore Info |
Hydraulic Plate Assembly
Fits tractor(s) : JUBILEE, NAA$34.68 eachMore Info |
Drag Link Tube (RH)
Fits tractor(s) : 2000, 2300, 3000, 3300$64.76 eachMore Info |
Ford/New Holland Hydraulic Cylinder Seal Kit
Fits tractor(s) : $64.38 eachMore Info |
Nut & Ring, Rear Axle
Fits tractor(s) : 8N, NAA$16.55 eachMore Info |
LOWER 3 PT ARM SUPPORT PIN
Fits tractor(s) : 2000 SERIES, 3000, 3600, 4000 SERIES, 4600, 501 SERIES, 600 SERIES, 700 SERIES, 800 SERIES, 8N, 900 ...$59.24 eachMore Info |
Battery Connector Cable
Fits tractor(s) : FITS SEVERAL MODELS$14.42 eachMore Info |
Filter, Inner Air
Fits tractor(s) : 8730, 8830, TW25, TW30, TW35$42.77 eachMore Info |
REAR SPINOUT RIM STOP
Fits tractor(s) : 1200, 1600 SERIES, 1710 DIESEL 3 CYLINDER, 1811 SERIES, 1821, 1910, 2000 SERIES, 2110, 2120, 2130, 2...$39.90 eachMore Info |
Ford/New Holland Hydraulic Seal Kit
Fits tractor(s) : $118.01 eachMore Info |
Ford/New Holland Hydraulic Cylinder Seal Kit
Fits tractor(s) : $109.22 eachMore Info |
Ford/New Holland Red Handle Hitch Pin 1" Pin Dia.
Fits tractor(s) : $19.09 eachMore Info |
Manifold, Exhaust (Horizontal)
Fits tractor(s) : 2000, 2600, 2610, 3000, 3230, 3430, 3600, 3610, 3930, 4000, 4130, 4600, 4610, 4630$92.31 eachMore Info |
Ford 9N 2N 8N Battery Door Handle And Latch Assembly
Fits tractor(s) : 2N, 8N, 9N$24.63 eachMore Info |
Oil Seal, Front Axle, Pinion Input Shaft
Fits tractor(s) : 6710, 7610, 7710, 7910, 8210, TW25, TW5$26.00 eachMore Info |
SEALED BEAM BULB 6 VOLT
Fits tractor(s) : 2N, 600 SERIES, 630, 640, 650, 700 SERIES, 740, 800 SERIES, 820, 840, 850, 860, 8N, 900 SERIES, 960,...$37.53 eachMore Info |
Tie Rod End (LH)
Fits tractor(s) : 2810, 2910, 3910, 4110, 4600, 4610$102.42 eachMore Info |
Ford/New Holland Muffler Inlet I.D. 1-7/8
Fits tractor(s) : $59.07 eachMore Info |
Fender Assembly
Fits tractor(s) : 2N, 8N, 9N, JUBILEE, NAA$174.89 eachMore Info |
Bushing, Rear Pivot
Fits tractor(s) : 3230, 3430, 3930, 4000, 4100, 4130, 4330, 4340, 4600, 4610, 4630, 4830, 5030$9.37 eachMore Info |
Hood Decal
Fits tractor(s) : 8700$72.32 eachMore Info |

The first Ford-Ferguson tractor was the Ford 9N. The Ford 9N tractor was first first seen in 1939. A simple tractor, the Ford 9N was fitted with the Ferguson system three-point hitch, a three-speed transmission, and featured foot pegs instead of running boards. The 9N's relatively tall and wide-spaced front wheel design resulted in sluggish steering and reduced maneuverability. The Ford 9N exhaust was routed underneath the tractor, much like an automobile. All Ford 9N tractors were painted Ford dark grey. This tractor has a rear Power Take Off (PTO) which could be used to drive three point or towed implements. The Ford 9N tractor was relaunched as the Ford 2N tractor in late 1941. The Ford 2N tractor also shone Ford dark grey. The Ford 2N tractor, and the Ford 9N tractor both had 3-speed Ford N-series transmissions. All of the Ford 9N and Ford 2N tractors have front-mounted distributor, which proved difficult to service. Manufacturing of the Ford *8N* tractors began in 1947. Complete with the Ferguson System three-point hitch and 4-speed transmission, the Ford 8n tractor was a very complete tractor. The Ford 8N tractor has a 4-speed transmission instead of a 3-speed in the Ford 2N and Ford 9N, and has more horsepower.